New to the hobby using the above transmitter. It successly flew on the first flight with the instructor in control. New to the hobby so I crashed on my first attempt to fly it.
realized that I needed a trainer device. Ordered a second transmitter to use for training.
I am using the Detrum SR86A-G receiver
with an experienced friend RC flyer, we followed the Trainer Set instructions
When the two transmitters were interconndected with the trainer cable, we experienced erratic glitching and instability of the control surfaces. When either transmitter was used and binded independtly to the receiver they worked fine. We tried everything we could think of for over an hour with no solution. reviewed the Trainer set instructions. Has anyone else experienced a similar problem? We ran out of ideas.
