@Chris Hall I now think that the SR86A has damaged accelerometers and/or gyros because it no longer funcions properly for a normal wing plane. Anything above a gain of 1 causes massive oscillations...

Dynam is turning 22 — and we couldn’t have done it without you. To celebrate, we’re launching a special anniversary event with exclusive offers and a community giveaway. ✈️ An...

Take it anywhere. Fly it everywhere. Coming soon. 👀✈️ A new lightweight park flyer is on the way — designed for easy, relaxed flying wherever you’ve got space. Stay tuned for th...

Pre-ordered! Is shipping from USA warehouse and what is the expected shipping date? Looking forward to flying it. Thanks

1. Is this being shipped from USA warehouse? 2. Expected shipping date ?   Thank you

Unfortunately the color is totally wrong. I might consider buying if only the color is correct, not necessarily 100% correct. At least should  be grey.  

I have 4 Detrum receivers with gyros and the three in normal wing planes behave as expected when switched between manual, normal and safe modes. However my SR86A in a delta wing plane with elevons ...

Cool!!

Some of you probably remember this teaser from last year…And yeah — you guessed it right.The E-2C Hawkeye is finally here.We’ve been working on this one for a while, and the goal...

I purhased two new retracts with the circuit board.  They work fine, although there is one problem.   The new retracts did not have a set screw,  therefore someone will need to ...

Hello,Does the Detrum SR86A-G receiver and Detrum Blitz-DT9 9CH support ducted fan jet?  Thank you.

Greetings, I'm new to the hobby so I appreciate any suggestions please. I recently received the Dynamrc Cirrus SR22 PNP +IStone. Plane arrived without the IStone stability but I was able to connect...

Hi dynam I purchased one meteor on 7 dec 25.My order no is 6776774228 and I was provided tracking no ET904464803SG..while tracking it is not updated since my order..it is showing on Singapore post...

I had a similar concern when waiting for a response about my order, and it can be really frustrating when communication goes quiet. Sometimes companies experience delays due to high order volume or...

I got 2 wire harnesses for the waco, 1 with servo connector and one without. Do I need to use both? And is there a diagram that shows the hook up?

i'm trying a couple of ones off amazon, haven't got them yet. I'll post when I do.

I I purchased a Detrum Z3 FPV V2 EP flight controller from Dynam Hobby, featuring return to home (RTH), a 3-in-1 OSD, and a PMU (order placed on August 25, 2025). However, since then, I've encount...

Is there a installation/setup guide for the Dynam F4U Corsair E-Retract w/ Strut & Wheel? It comes with a circuit board but Im not sure how it works. Can you help please?

The servo arms were not setup to be at the same position when the transmitter connected to the receiver.   I had to change one of the servo arms to be the same.   Also,  th...

I fixed the above by going through calibration 3 times.  However I have found the digital trim for elev. rudd. don't work. the expo just makes the center a dead spot on the stick. No way to mi...