✨🔄アップグレード！Dynam Cessna (セスナ) 188 クロップダスター V2 レッド 4S RCスケールプレーン 1.5m フラップ付き

I have purchased many dynam planes in the past but it has been a while. This is what they got right and what was wrong. The packing was acceptable, none of my parts were damaged. As usual the manual really sucks. They have a huge page for setting the control throws and tiny little pictures for the actual assembly of the plane. This is backwards! Right out of the box my motor had excessive end play in the motor shaft and the bearings sound like they have rocks in them. I was pleasantly surprised to see the motor was 800kv! this is good, more realistic for the size prop you can spin. Also a 50 amp esc. Also good. The system for assembling the wing is really bad! It could go wrong in so many ways. I installed the center section on the fuselage first. I wanted to use epoxy to glue on the wing segments but you would literally have to stand there for an hour holding the pieces together. There is no way to glue it and step away. I ended up using C.A. foam glue and accelerator so I could align the parts and spritz with accelerator. then I installed the trusses on the top of the wing, then last I installed the braces that go in the slots on the bottom of the wing. Last I glued on the wing tips. This is probably the best chance to keep this all together and aligned. Everything else went together well. No worries with the vertical and horiz. stabs except the screws were too short! I dug through my extras and found some longer. This in my opinion is unacceptable. another annoying point is I noticed that the wheels use 3mm bolts for axles and the plastic hub rolls right on the threads of the bolt. This is like using a file for an axle! also unacceptable. I reamed out my wheels to 4mm and cut 2 brass sleeves 3mm inside dia. 4mm outside dia. and slipped them over the axle bolts. This should last a long time! The tail wheel is the same way, rolling on threads. It flies well but as I have seen with some other dynam planes the angle of the vertical stabilizer must be wrong. I flew mine very neutral and I had to trim the elevator up a ton to get it to fly straight. This to me also is unacceptable. To finish, I was happy that they now install the flap servos, this is an improvement. The plane does look cool. The paint is poor with rough transitions from red to white. Like overspray. A lot of quality has improved but you still have a ways to go. Keep at it! I am cautiously optimistic!